Groupe Sanbaro
 
 
     

Founded on our experience in the test bench field, our engineers have developed a wide range of products named TestAvenue™, including software, electronic equipment and payload test benches, communication bus simulators / analysers and the whole spectrum of I/O cards.

These standard TestAvenue™ products are used in applications involving test equipment for power distribution, motor controls, OBDH, MACS, 1553 bus terminal units…, satellite platforms, on-board computers and different payloads.

 

OBDH BUS

OBDH Bus controller (CTU simulator)
TestAvenue™ -DIS60500
The OBDH Bus controller (CTU simulator), designed to be incorporated into a PC type computer, enables interrogation messages to be generated and responses to be received from bus terminals units in real time.

OBDH bus terminal unit simulator and analyser (ITU simulator)
TestAvenue™ -DIS60510
Designed to be incorporated into a PC type computer, it is used to simulate up to 32 OBDH bus subscribers of RTU or ITU type and to perform a spy function on interrogation and response busses.

- top -

MACS Bus

MACS Bus controller
TestAvenue™ -DIS60550
 This very effective tool, which can be incorporated into a PC type computer, is used to test any subscriber equipment connected to MACS bus.

MACS bus analyser.
TestAvenue™ -DIS60570
 Designed to spy on the 2 redundant MACS bus lines.

MACS bus terminal unit simulator
TestAvenue™ -DIS60560
This simulator is used to emulate a terminal unit connected to 2 redundant MACS buses (data lines and clock).

- top -

16 bit serial links (CS16, AS16)
& discrete TM/TC interfaces

SCDI (Serial Command and Data Interface) simulator
TestAvenue™ -DIC60400
 Used to generate programmable 16 bit serial commands (CS16 master mode type) and receive 16 bit serial data (AS16 master mode type) on 2 redundant, independent interfaces.

VXI SC16 & SA16 master-board
TestAvenue™ -DIC60410
 Emission and reception in simple, burst and block modes of 16 bit serial commands and 16 bit serial data.

VXI SC16 slave board
TestAvenue™ -DIC60420
 16 bit serial data acquisition on receipt of clock and sampling signals on 2 independent channels.

VXI SA16 slave board
TestAvenue™ -DIC60430
 The VXI SA16 slave board is used to send 16 bit serial data on receipt of clock and sampling signals on 2 independent channels.

I/O CARDS
Discrete TM/TC interfaces
TestAvenue™ -DID60100
 Available in different formats (VXI, PXI, etc.), this board generates ON/OFF type commands (High level) and short commands, and acquires relay commands and bi-level type status.

 

- top -

Plasma propulsion EGSE

TestAvenue™-MBL10100
 The plasma propulsion EGSE drives electronic modules operating plasma motors: generation of commands, acquisition and monitoring of motor parameters.

 

DORIS

DORIS beacon simulator (DBS)
TestAvenue™ -OBL10100
 The job of the DBS is to simulate a radio-electrical signal emitted by beacons such as the one received by the DORIS instrument in orbit.

DORIS TM Processor (DTP)
TestAvenue™ -OBL10200
 The DTP is used to perform off-line processing of Doris remote measurements and to run the on-board equipment by its test plug.

 

DORIS interface satellite simulator (DISS)
TestAvenue™ -OBL10300
 The DISS is used to simulate the Doris instrument interfaces signals (excluding RF signals) in order to perform functional verification tests and the Doris instrument ground qualification tests.